![]() ![]() Use the Image > Image Size control to see how large your cropped test strip is (re-crop it if necessary to ensure it fits on the sheet of paper). Step 5: Repeat the steps above until you reach the point where you position your second test strip. ![]() Make the required changes to the saved image file and, if you wish to check them again, get ready to make a second test strip on the same sheet of paper as you used for the first. Now assess the test strip, checking colour, brightness, sharpness and any other adjustable parameter that is relevant. Step 4: Print the test strip using the settings you will use for the final print. ![]() Uncheck Centre Image and use the Position settings to position your test strip on the sheet of paper. Then return to your software application and select Print. Open the printer driver and set the paper size and orientation to match the paper you’re using. Step 3: Load the printer with a sheet of the paper you will use for your final enlargement and re-set the paper size and orientation accordingly. If this is the case, tag the file name with ‘test’.) (There is no need to save the ‘test strip’ unless you wish to use the same area subsequently. Do not change the size of the image as this could change the print quality. The strip should be rectangular but it can be almost any size you want – as long as it covers the key ‘exposure’ area. ![]() Step 2: Using the Crop tool, select a strip that runs through a critical area of the image where you want detail to be fully resolved. To place it on a canvas size of 32.9 x 48.3cm (A3+ size), simply change the New Size Width and Height to 32.9 x 48.3cm. In the example shown, the image size is 19 x 25.33cm, which fits on an A4 sheet with a narrow white border. If you want white borders, this is the time to use the Image > Canvas Size setting to position your image on the page. Step 1: Edit the image in your favourite software application and save it separately at the correct output size – either in a special ‘printing’ folder or with the tag ‘for printing’ added to the file name. However, there’s an easy way to minimise the amount of paper you use to check the image will print correctly: make test strips. If you are forced to print with an uncalibrated monitor and rely on a non-colour-managed workflow, you can waste a lot of ink and paper. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |